ADC Error Code FLAME — Flame fault

Service Guy AI • Dryer • Medium severity • Basic skill • ~45 min repair

Quick fix: Primary fix: Flame Sensor (ADC-009P) - $25

What Does ADC Error Code FLAME Mean?

Flame fault. Fix rate: 89%

This is a medium-severity fault. The machine may complete the current cycle but is signalling a problem you should resolve before it escalates.

Possible Causes (3)

ADC engineers identify the following root causes for fault code FLAME. Work through them in the order shown — they are listed from most common to least common.

  1. Component failure
  2. Wiring harness issue
  3. Control board malfunction

Step-by-Step Troubleshooting (7 steps)

Follow this sequence to diagnose and clear ADC error code FLAME. Power down and unplug the machine before any internal inspection.

  1. 1. Disconnect power and verify zero voltage before servicing
  2. 2. Note the exact error code display and any flashing patterns
  3. 3. Inspect related components for visible damage
  4. 4. Check wiring harness connections
  5. 5. Test component with multimeter if applicable
  6. 6. Replace faulty component and test operation
  7. 7. Clear error code and run test cycle

Required Parts

Have these ADC OEM part numbers ready before starting the repair. AAdvantage Laundry Systems carries verified parts for every code in this database.

  • Flame sensor
  • Ignition module
  • Control board
  • Wiring harness

Diagnostic Test Mode

Enter ADC diagnostic test mode: Hold 'High Temp + Start'

Skill Level & Repair Time

This repair is appropriate for an experienced laundromat owner or in-house technician. You should be comfortable removing service panels, reading wiring diagrams, and using a multimeter to test continuity and voltage. Plan for approximately 45 minutes of active repair time once parts are on hand.

Get AI-Powered Diagnosis

If the steps above don't resolve ADC FLAME, run a free Service Guy AI diagnosis. Upload a photo of the error display and get an AI-generated repair plan tied to your exact ADC model number, including supplier links for required parts and on-call technician escalation.

Other ADC Error Codes

E1 — Error Code E1E5 — Error Code E5E9 — Error Code E9IGNITION — Ignition faultEXHAUST_LIM — Exhaust high limit faultE8 — Error Code E8LOW_VOLTAGE — Low voltage faultSAIL_CLOSED — Sail switch closed fault
All ADC Error CodesAll Error CodesService Guy AI DiagnosisOrder OEM PartsEquipment Hub

By — Founder, WashBizHub. Third-generation laundromat operator. Reviewed by the WashBizHub editorial team.

 · 

WashBizHub — Laundromat Industry Intelligence Platform. Contact · About · Privacy Policy · Terms of Service

© 2026 WashBizHub. WashBizHub is editorially independent. Where we earn affiliate revenue (e.g., AAdvantage funding referrals), it is clearly labeled.