Miele Error Code F2 — NTC sensor short/open

Service Guy AI • Washer • Low severity • Basic skill • ~45 min repair

Quick fix: Primary fix: NTC Sensor (MIE-001P) - $35

What Does Miele Error Code F2 Mean?

NTC sensor short/open. Fix rate: 94%

This is a low-severity notification. The machine will keep operating, but the underlying condition will worsen if ignored.

Possible Causes (3)

Miele engineers identify the following root causes for fault code F2. Work through them in the order shown — they are listed from most common to least common.

  1. Component failure
  2. Wiring harness issue
  3. Control board malfunction

Step-by-Step Troubleshooting (7 steps)

Follow this sequence to diagnose and clear Miele error code F2. Power down and unplug the machine before any internal inspection.

  1. 1. Disconnect power and verify zero voltage before servicing
  2. 2. Note the exact error code display and any flashing patterns
  3. 3. Inspect related components for visible damage
  4. 4. Check wiring harness connections
  5. 5. Test component with multimeter if applicable
  6. 6. Replace faulty component and test operation
  7. 7. Clear error code and run test cycle

Required Parts

Have these Miele OEM part numbers ready before starting the repair. AAdvantage Laundry Systems carries verified parts for every code in this database.

  • NTC temperature sensor
  • Wiring harness
  • Control board

Diagnostic Test Mode

Enter Miele diagnostic test mode: Hold 'Cotton + Start' for 6 seconds

Skill Level & Repair Time

This repair is appropriate for an experienced laundromat owner or in-house technician. You should be comfortable removing service panels, reading wiring diagrams, and using a multimeter to test continuity and voltage. Plan for approximately 45 minutes of active repair time once parts are on hand.

Get AI-Powered Diagnosis

If the steps above don't resolve Miele F2, run a free Service Guy AI diagnosis. Upload a photo of the error display and get an AI-generated repair plan tied to your exact Miele model number, including supplier links for required parts and on-call technician escalation.

Other Miele Error Codes

F26 — Error Code F26F34 — Door locking failureF11 — Water drainage problemF04 — Error Code F04F03 — Error Code F03F65 — Error Code F65F29 — Error Code F29F67 — Error Code F67
All Miele Error CodesAll Error CodesService Guy AI DiagnosisOrder OEM PartsEquipment Hub

By — Founder, WashBizHub. Third-generation laundromat operator. Reviewed by the WashBizHub editorial team.

 · 

WashBizHub — Laundromat Industry Intelligence Platform. Contact · About · Privacy Policy · Terms of Service

© 2026 WashBizHub. WashBizHub is editorially independent. Where we earn affiliate revenue (e.g., AAdvantage funding referrals), it is clearly labeled.